I did the recap on the PSU for my Master and in the retroclinic instructions it said to set the voltage while not under load, so I tweaked it down to 5v as it was reading about 5.2v (I hadn't tested voltages before recapping it) and when under load on the master odd things started happening where the cmos seemed to be corrupted on startup. I tried going into the cmos settings from the welcome disk and it just hung. I tried measuring the voltage and under load it had dropped to 4.7v, so I just tweaked it back up to 5v and the cmos setting immediately appeared on the screen. That was probably about a year ago and everything has been fine with the master since then.
Statistics: Posted by growntree — Thu Nov 14, 2024 10:49 am
