Thanks Jonathan, performing a SAVE, this is what I see:And this is what's sniffed from the serial line:The green highlight are the commands and prompt, the red is the tokenized program matching the RAM dump above; then the &9B,&00,string (save file name). What I'm not sure about is the preamble to the control block (data transfer):SAVE Tx: &9B,&00,string,control block (data transfer),&9B,&04
Code:
FF FF 0E 10 FF FF 0E 00 FF FF 80 23 FF FF 0E 00I'm going to take a look at your EURO414 source to determine if the preamble block looks correct. My other thought is that I used my B+ to SRLOAD EURO414 into sideways RAM rather than burning an EPROM, but will try on my B in case there's some sort of B+ compatibility issue.
Statistics: Posted by *STEVE — Wed Jan 01, 2025 7:26 pm