Hi,
I need to build a very simple internal device to go in to Master 128, in which both the user port and 1Mhz bus are already in use.
For simplicity's sake, I'm looking at using the Modem port that sits on the left hand side of the motherboard.
I note the presence of the 1MhzE pin on this connector (PL12). Are there any special considerations in using this, e.g. similar to debouncing NPGFC on the 1Mhz bus?
Ta
-- Rebecca
I need to build a very simple internal device to go in to Master 128, in which both the user port and 1Mhz bus are already in use.
For simplicity's sake, I'm looking at using the Modem port that sits on the left hand side of the motherboard.
I note the presence of the 1MhzE pin on this connector (PL12). Are there any special considerations in using this, e.g. similar to debouncing NPGFC on the 1Mhz bus?
Ta
-- Rebecca
Statistics: Posted by Phu — Mon Nov 18, 2024 12:25 pm